 
The CMCP801 Probe Holder is designed for the external mounting of
proximity probes as described and recommended by API-670. External
(through the case) mounting allows for the easy removal, inspection, and adjustment of the
proximity probe as opposed to internal mounting where the bearing cap or cover needs to be
removed prior to inspection.
The CMCP801 Probe Holder is available in various lengths and has an
adjustment range of plus or minus 1" (2.54 cm), 2" (5.08 cm) overall
adjustment). When ordering, the insertion depth should be measured, or calculated, and the
closest standard length selected. The broad adjustment range will allow for any
discrepancies. In some cases Probe Holders are ordered in their longest length and cut in
the field when the machine is open and available for measurements.
All machined parts of the CMCP801 Probe Holder are made of 316
Stainless Steel. The outlet body and extension are cast aluminum. The outlet body is
provided with four (4) 3/4" NPT Hubs and is rated for Class 1 and 2, Division A, B, C
and D.
As the Probe Holder uses 3/4" NPT entry into the machine case
standoff's, if required, can easily be constructed using readily available 3/4" pipe
and pipe fittings.
Each Probe Holder is provided with the following:
-
(1) Outlet Body w/Dome Lid
-
(3) Close up Plugs 3/4" NPT
-
(1) Probe Adapter Union 3/4" NPT
-
(1) Probe Holder (Stinger)
-
(1) Jam Nut 1-1/4" Wrench Size
-
(1) Parker Seal
-
(1) Flat washer
|
